My FT-991 does not stop scanning

My FT-991 does not stop for 5 seconds when scanning

Cause/Symptom:
My FT-991 does not stop for 5 seconds when scanning

Solution:
The FT-991 does stop on the received signal when scanning, but you must first adjust the squelch to level 9.

There are 2 settings for scan, one is TIME and the other is PAUSE. If the radio is set for TIME, the FT-991 will stop on the received signal for 5 seconds and then resume scanning even if the signal is still present. If set for PAUSE, the FT-991 will stop and remain on the signal until it is no longer present.
Labels: , , , , , , , ,

1 comment:

  1. Unknown5/25/2017

    Thank you,,, no where in the manual does it tell you to set the squelch to 9,,, works great now

    ReplyDelete

Thanks for your comments, Comments may take a day to show up

Digital Ham Radio / Amateur Radio
DigitalHamRADIO@groups.io
https://groups.io/g/DigitalHamRADIO

Yaesu FT-991(A) Users Group (groups.io)
https://groups.io/g/Yaesu-FT-991

www.FT991a.com
www.FTDX10.com
.

Note: only a member of this blog may post a comment.

Subscribe to: Post Comments (Atom)